The activation theory of slag in blended cement

As it is well-known, the activation of latent slag in blended cement is implemented by calcium hydroxide (CH, Ca(OH)2) which is the main cause maintaining the high pH value of pore solution. The activation happens as the break of glass layer of slag particles. However, how does the break take place in detail? Researchers have already proposed a theory to explain the process, which will be discussed in the post. The main composition of glass is SiO2, thus the break of glass layer is actually the break of chemical bond between Si and O (Si-O). In the first step, the bond Si-O is broken by hydroxyl, ...

2012-07-02 · 1 min · 181 words · Cement Science

Features of microstructure development in the inner product of reacting slag in blended cement

The morphology of inner product region derived from alite or belite is identical to those present in neat OPC paste. In mature pastes, fully hydrated small grains of both alite and GGBFS often display a coarse morphology. Generally, inner product in larger grains has a dense homogeneous morphology with very fine porosity, and large slag grains often have a rim of fine textured C-S-H which can exist for many years and merge into outer product C-S-H gel. Mg, Al-rich laths or possibly platelets present within the inner product C-S-H gel, which are oriented either towards the outer boundary of the inner product or randomly even at the outer boundary. ...

2012-06-14 · 2 min · 248 words · Cement Science

Features of microstructure development in the outer product of reacting slag in blended cement

Similar to Portland cement, microstructure of slag hydrate could also be classified as inner product, which formed within the boundaries of the original anhydrous grains, and outer product that formed in the originally water-filled spaces. The major phases present in the outer product region of neat OPC pastes are C-S-H gel, Ca(OH)2, AFm and AFt. The addition of slag affects the morphology of the microstructure of slag blended cement. The morphology of the outer product C-S-H varies with chemical composition, viz. at high Ca/Si ratio it has a fibrillar morphology which gradually changes to foil-like with a reduction in Ca/Si ratio. In pure OPC or with low slag loading, amorphous C-S-H has a strongly linear directional characteristic being fibrillar in its appearance in the TEM. At approximate 75% GGBFS regions of foil-like C-S-H form without these linear characteristics. ...

2012-06-13 · 2 min · 297 words · Cement Science

Hydration products of slag in blended cement

Many XRD analysis results have shown the main hydration products of slag blended cement are essentially similar with that of pure Portland cement, except the amounts of CH found by this method or other are in varying degrees and less than those that should be given by the pure Portland cement constituent if the slag part did not participate the reaction. The main hydration products of the slag-cement are C-S-H gel, Ca(OH)2, the sulpho-aluminate hydrate phases AFt and AFm and a Mg, Al-rich hydroxide phase. ...

2012-06-11 · 2 min · 267 words · Cement Science

Activation of slag in blended cement

The latent hydraulic property of slag means no hydration products could be observed when slag is solely placed in contact with water, though surface analysis using X-ray photoelectron spectrometry showed that the surface of slag was modified as soon as it came into contact with water making a protective film lacking Ca2+ that prevent further reaction, thus, slag dissolves to a small extent. ...

2012-06-10 · 3 min · 493 words · Cement Science