Factors affecting the reactivity of slag

The exact composition of slag varies over a range. In general, factors that determine the suitability of slag for usage in composite cement mainly include the fineness of grinding, glass content and the chemical composition. Fineness Like most of other cement materials, the reactivity of slag is influenced by its surface area. Increased surface area leads to better strength development and more water requirement; however, the fineness of slag is limited from practical aspects, such as economic and performance considerations, setting time and shrinkage. The following table shows typical fineness data of market slag in some countries. ...

2012-06-07 · 4 min · 670 words · Cement Science

Microstructure development of limestone blended cement

Though the chemical reaction of the fine particles of limestone in cement paste is limited to a low extent due to its inert property, the addition of limestone particles has significant effect on the microstructure development. Research conducted by Sellevold et al. using mercury intrusion method showed that specimens containing 12% CaCO3, which have the main body of the particles smaller than 0.1 µm had finer pore structure and somewhat reduced total pore volume. ...

2012-06-05 · 3 min · 521 words · Cement Science

Low reactivity and reported reaction extent of limestone in blended cement

The extent of reaction of limestone with cement clinkers is relatively low than the corresponding values of cement clinkers, the probable cause for this as stated above arise from the low solubility and low reactivity of limestone particles, though other factors of limestone, including fineness, particle size distribution, etc., do have influence on its reaction degree in blended system. In experiments of 5% or 15% calcium carbonate reaction with type II cement hydrated up to one year, Klemm and Adams observed that monocarbonate hydrate is formed slower than that of ettringite, and after 129 days hydration, the amount of unreacted CaCO3 is still up to 80-90%. Ramachandran investigated that in mixtures hydrated with 15% and 5% limestone substitution, the amounts of limestone reacted with the hydrating C3S were reacted within the first 3 days. A typical simulation performed by Bentz showed that for a 20% by mass fraction substitution of ground limestone for cement, only about 5% of the limestone present reacts during the first 180d of hydration. ...

2012-06-04 · 2 min · 332 words · Cement Science

Chemical reaction of limestone with C3S and C3A

The hydration rate of C3S is accelerated in the presence of limestone probably because of the dilute effect and the multiplied nucleation sites. Jean Pera et al. reported that the total heat resulting from pure C3S hydration was 145 joules while that of the mixture (50%C3S+50%CaCO3) reached 260 joules. Ramachandran’s investigation showed that some calcium carbonate was consumed as the hydration of Portland cement proceeded. The product of the reaction of limestone and C3S is calcium carbosilicate, whose exact type cannot be identified by X-ray diffraction probably due to its amorphous property and small amount of formation. ...

2012-06-02 · 2 min · 352 words · Cement Science

Physical effects of limestone on the hydration of cement clinkers

Effects of limestone addition on the hydration of limestone blended cement can be classified into two aspects, viz. physical effects and chemical effects. Numerous researchers who investigated Portland limestone cement with high level of calcite addition regard it as inert filler, e. g. by means of both thermal and BSE image analysis, it was investigated by G. Ye et al. that limestone powder does not take part in the chemical reaction at all. ...

2012-06-01 · 2 min · 265 words · Cement Science